Service details
Exterior Hand Wash & Polish
We begin with a two-bucket hand wash to safely remove surface dirt without introducing new scratches. A clay bar treatment follows, pulling out bonded contaminants the wash cannot reach. Then a machine or hand polish restores clarity to the paint surface, reducing swirl marks and light surface imperfections.
This service is suitable for vehicles that have visible surface dullness, swirl marks, or a build-up of road film. It does not address deep scratches that have penetrated the clear coat.
- Two-bucket wash method with microfibre mitts
- Clay bar decontamination
- Single-stage machine polish
- Tyre dressing and rim clean
- Exterior glass polish
Interior Deep Clean
A thorough interior clean addresses every surface inside the vehicle — seats, carpets, door panels, dashboard, console, and vents. We use dry vacuum extraction first, then wet extraction for fabric seats and carpets where needed. Hard surfaces receive an appropriate interior cleaner and protectant.
Leather seats are cleaned with a leather-specific product and conditioned to prevent drying. Fabric seats receive a foam extraction treatment. We don't use products that leave a greasy film on surfaces.
- Full vacuum extraction (seats, carpets, boot)
- Wet extraction for fabric upholstery
- Leather clean and condition
- Dashboard, console, and door panel wipe-down
- Interior glass cleaning
- Vent and crevice cleaning
Paint Protection Treatment
Applied after polishing, a protection layer seals the paint surface against UV degradation, dust adhesion, and environmental contaminants. We offer two options: a natural carnauba wax for a warm gloss finish, or a synthetic polymer sealant for longer-lasting protection suited to Egypt's climate.
Protection treatments are not permanent coatings. They require reapplication periodically depending on conditions and use. We'll advise on what's appropriate for your vehicle during the visit.
- Carnauba wax (warm gloss, natural finish)
- Synthetic sealant (longer durability, UV resistance)
- Applied by hand or machine depending on product
Engine Bay Cleaning
We apply a degreaser to engine bay surfaces, allow it to dwell briefly, then rinse carefully with low-pressure water. Sensitive electrical components and connectors are protected or avoided throughout. After rinsing, plastic and rubber components receive a dressing to restore their appearance and prevent drying.
This service is cosmetic — it addresses the visual cleanliness of the engine bay. It does not involve any mechanical work, diagnostics, or component inspection beyond what's visible on the surface.
- Degreaser application and dwell
- Low-pressure rinse (sensitive components protected)
- Plastic and rubber trim dressing